E-liquid Cheesecake - 10 ml
Enjoy the decadence of the richest cheesecake around when you sample this cheesecake-flavoured e-liquid. With this in your arsenal of flavours, you can satisfy your sweet tooth whenever it hits. The best part is that you can taste it as often as you like because this calorie-free treat won't sabotage your diet by adding a single bit of fat to your body.
Warning: Last items in stock!
Two Easy Methods for Refilling Your Electronic Cigarettes
If you’ve recently made the switch to electronic cigarettes, you can purchase pre-filled cartridges or refill your own cartridge with e-juice. Replenishing your cartridges rather than throwing them away can save you some money. To refill empty electronic cigarettes cartridges, you will need to get e-liquid and other necessary materials.
How to Refill It
Injection Technique with a Syringe
For this technique, you will need e-juice and a syringe, though an injector may also work. Many people prefer using the syringe, as it prevents the e-liquid from getting all over the electronic cigarettes. It allows you to scatter juice uniformly along your cartridge filler, and it is much easier to draw out your e-liquid from the bottle.
Start by removing the white rubber cap at the end of the cartridge using a little screwdriver or tweezers. Take the syringe and use it to draw out e-juice from your bottle. Once done, place the syringe’s needle into the middle part of the e-cig cartridge filler so that you’re near the base of the empty cartridge.
If you’re refilling a two piece cartridge, you may want to make sure that you place the needle pointing toward the mesh located within the tube. That way, you’ll avoid damaging the atomizer. Press the syringe plunger slowly while shifting the needle at the same time. The aim here is to ensure a uniform fill of the electronic cigarette without overloading.
The Drip Method
This technique is the most common method for refilling electronic cigarettes. The materials you’ll need for this are the e-juice and the dripper. Start by removing the cap on the end of your cartridge using a thumbtack or anything else that’s sharp enough to fit into the small hole. Note that sometimes the cap may be glued on very tight and could break when you’re trying to pull it off.
Once you open up the cartridge, remove the polyester stuffing inside and then drip a few drops of the e-liquid into the cartridge using a dripper. Gently put back the stuffing and allow a few minutes for the stuffing to absorb the e-juice. Add a few more drops to the stuffing material to ensure it’s sufficiently soaked, but not to the point where the liquid builds up at the top.
Push the stuffing in and add enough drops so that the stuffing is completely soaked. Close the cartridge. The drip method technique takes some time and a lot of perseverance because you have to allow the stuffing to become totally soaked.